Factory-direct-hardware Hansgrohe 10175001 Bedienungsanleitung Seite 1

Starck10101XX110140XX1Starck10106XX110145XX1Starck X10170001101750011018000110185001Installation Instructions / Warranty

10Turn the water on (1).Reconnect the power cable (2).Wait 30 seconds (1).Place a hand in front of the sensor to turn the faucet on (2).

11CleaningThe faucet may be turned off temporarily so that the sink may be cleaned.Cover the sensor window with a hand for approximately 10 seconds.Th

12Change the Spray Former -- Starck X 10170 / 10175 / 10180 / 10185 onlyThe waterfall spray former is installed on the faucet at the fac-tory. A roun

13Reduce the Sensor RangeThe sensor is set for maximum range at the factory. If the faucet is used on a very small or highly reflective lavatory, the

14Replacement Parts1 battery, lithium CR-P2 / 6V2 connection hose 988090003 spray former 988670004 aerator, Starck 94005XX05 fixing set 1396

15Limited Lifetime Consumer WarrantyThis product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”).

Hansgrohe, Inc. • 1490 Bluegrass Lakes Parkway • Alpharetta, GA 30004Tel. 770 360-9880 • Fax 770 360 9887www.hansgrohe-USA.comUS - Installation Instr

2Starck10101XX1/10106XX1Starck10140XX1/10145XX1Starck X10170001/10175001Starck X10180001/10185001

3Starck10101XX1/10106XX1/10140XX1/10145XX1Starck X10170001/10175001/10180001/10185001Technical InformationRecommended water pressure 15 - 58 psiMax.

4Installation notes• Flush the hot and cold supplies thoroughly before installing the faucet. Damage to the faucet caused by debris is not covered u

5InstallationPosition the faucet on the sink or countertop (1).Install and tighten the mounting nut (2). Tighten the tensioning screws (3). Connect

6Connect the faucet power cable to the battery pack or AC power pack (1). Plug the AC power pack in.Turn the hot and cold supplies on (2). Remove th

7Remove the faucet body (1).Turn the temperature screw forward to make the water cooler, backward to make it warmer (2).Dry any drops of water from th

8Battery Replacement -- models 10101XX1/10106XX1/10170001/10175001 onlyIf the LED in the sensor window flashes, the battery is low, but the faucet can

9Clean the aerator and filters -- all modelsIf the water flow is reduced over time, clean the aerator (a) and the filters (b).Turn the water supplies