Factory-direct-hardware Von Duprin 9947EOF Bedienungsanleitung PDF herunterladen

VON DUPRIN

Installation Instructions

Devices covered by these instructions:

98/9947 Concealed Vertical Rod Exit Device

98/9947-F (Fire) Concealed Vertical Rod Exit Device

CD98/9947 (Cylinder Dogging) Concealed Vertical Rod Exit Device

EL98/9948-F (Electric Latch Retraction) Concealed Vertical Rod Exit Device

This product is covered by the

following patent numbers:

3,767,238 4,427,223

3,854,763 4,466,643

4,167,280 4,741,563

98/9947 Concealed Vertical Rod Exit Device

Metal Door Applications

Special tools needed:

5/64” hex wrench

#10-24 tap

Drill bits: #25, 1/8”, 1/4”,

5/16”, 13/32”

911376-00

Index:

• Screw chart ................................... 2

• Door preparation chart .............. 3

• Device installation .................... 4-5

• Adjust rods .................................... 6

• Frame preparation chart ............ 6

• Optional equipment ................ 7-8

• Cut device ..................................... 8

2” Minimum clearance

(with endcap removed)

Device aligned

with mounting

holes

Tape and mark area being cut.

Cut device square.

Slide anti-rattle clip into device.

Measure amount to cut off device.

Anti-rattle

clip inside

2”

min.

OPTIONAL EQUIPMENT - CONTINUED

1. Remove mortise cylinder cam and reinstall in reverse (Figure 6).

2. Insert key and rotate cam to install the cylinder to the cover plate

(Figure 7).

3. Remove key to slide cover plate in position in the mechanism case.

Std. mortise

cylinder

Mortise

cylinder

cam

Std. mortise

cylinder

Mortise

cylinder

cam

CD function conversion

Figure 6

Figure 7

Std. mortise

cylinder

Cylinder

collar

Dogging

plate cover

Offset toward

pushbar

Cylinder

locating washer

Cylinder

lock nut

Mechanism

case

Turn cylinder key clockwise approx. 1/

8 turn for standard dogging

Dogging procedure

Depress pushbar

CD (CYLINDER DOGGING)

CUT DEVICE

If 5/8” diameter wire access hole

has been predrilled in door, cut

device 5/16” from center of hole.

Note

5/16”

Tape

Cover plate

(flush to pushbar)

Pushbar

Remove anti-rattle clip

Cut device square

and remove all

burrs

NOTE: Device must

be cut square for

proper end cap fit

Please give these instructions to building owner after device is installed

911376-00(4)

1 2 3 4

Inhaltsverzeichnis

Seite 1 - Installation Instructions

VON DUPRIN®Installation InstructionsDevices covered by these instructions:98/9947 Concealed Vertical Rod Exit Device98/9947-F (Fire) Concealed Vertica

Seite 2 - EL ADJUSTMENT PROCEDURE

#10-24 x 1” #10-24 x 1-1/2”Surface mount orSex bolts (2-1/4” door)Sex bolts (1-3/4” door)#10-24 x 3/4”#10-24 x 1-1/8”2ABCEFGHIJDSCREW CHART#8-18 x 3

Seite 3 - ADJUST RODS

Install bottom adjusting screw through bottomrod (Figure 2).With top latch bolt still retracted, adjust bottomrod so latch bolt clears floor and botto

Seite 4 - (optional)

3/32" R max.Stop9/16"1-1/8"3/8"CL1/8"Latch case5/8"Remove materialas necessary toaccomodate 5/8"latch bolt thr